Bowl as illustrated in the first picture below.
Bowl from a board stack lamination.
Prepare a sled for the planer.
Many years ago at an aaw symposium mike shuler a well known woodturner from santa cruz california demonstrated making a bowl with very little waste.
Bowl from a board band saw method piece.
However the bfab blank can be anything from a raw board to a complex glue up as illustrated below.
In conventional segmented ring construction many board feet of good wood goes into the trash.
Stacked ring lamination.
After shaping and sanding the bowl will be reversed using bowl jaws and.
The configuration below was inspired by michael mode and a bowl you can see on his web site www michaelmode.
Inspired by some bowls i had seen made by michael mode a little while ago i decided to jump straight in at the deep end and make this 500mm 19 5 bowl using the surprisingly simple technique stacked ring lamination.
Stack each layer up successively to go from flat board to 3d bowl in seconds.
No matter how the blank is prepared the bowl is cut stacked and glued up in the same way.
The bowl base was glued to a waste block which was then mounted to the lathe.
I used my lathe to smooth o.
Shown below are some of my favorite bowls created since 1999.
Bowl from a board.
I intend to add a piece of wenge to the base so i added a strip to build up one side.
I use a technique sometimes called bowl from a board in which a single square section.
Stack laminated rings make bowls with huge possibilities in colorful exotic woods.
Once all the walls were flat and smooth and all the layers were glued on the bowl could be given its final shape.